CARLO GAVAZZI LDI 35 - CONFIGURATION SOFTWARE Manual do Utilizador descarregar pdf (Página 16)

ENGLISH

• 2) the operator has already entered a Password: select the correct

password by means of the

key (to increase the value) or key

(to decrease it) until the desired value is displayed. Press the

key

to confirm the value: if the password is correct, then the display will show

“PAS” again followed by the relating numerical code; press the

key

once more in order to display the first configuration menu; if the password

is not correct, the display shows “End” and the instrument goes back to

the measuring and control phase.

PROGRAMMING OF A NEW PASSWORD AND AUTOMATIC SELEC-

TION OF THE PROTECTION LEVEL OF THE CONFIGURATION

DATA.

To enter the new Password:

•if the Password is “0”, press the

key when the display shows the

“PAS” message for the second time; enter the desired numerical code

using the

or keys, then confirm it by pressing the

key:

the display will show the first configuration menu (“inP”);

•if the Password has already been entered, you can modify it following

the procedure described at No. 2; after the “PAS” message has been

shown a second time, enter the new numerical code using the

keys and confirm it by pressing the

key: the display will show

the first configuration menu (“inP”).

Data protection levels:

•if the password is “0”, the configuration data are not protected by

undesired accesses;

Gross Automation (877) 268-3700 · www.carlogavazzisales.com · [email protected]

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Sem comentários

CARLO GAVAZZI LDI 35 - CONFIGURATION SOFTWARE Manual do Utilizador Página 16